CCNP系列認證章節(jié)練習(2019.05.09)

A.DTIM = 1
B.DTIM = 2
C.DTIM = 3
D.DTIM = 4

A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork

A.Access-list 101 was configured for the trusted interface， and access-list 100 was configured forthe untrusted interface
B.Access-list 100 was configured for the trusted interface， and access-list 101 was configured forthe untrusted interface
C.Access-list 100 was configured for the inbound direction， and access-list 101 was configured forthe outbound direction on the trusted interface
D.Access-list 100 was configured for the inbound direction， and access-list 101 was configured forthe outbound direction on the untrusted interface

A.AAA client and AAA server handshake failure
B.supplicant authentication failure
C.wrong password used by the supplicant
D.failure of the wireless client and AAA server handshake

A.Statically defined RP
B.Bootstrap Router
C.Auto-RP
D.RP Discovery Protocol（RDP）
E.RP Helios
F.RPARP（RARP）

A. ISR can perform the functions of a multipoint control unit to facilitate voice conferencing.
B. ISR can perform the function of a call agent in the event of loss of communication with a CallManager.
C. ISR can provide XML applications to the phones.
D. ISR can provide all of the functionality of a CallManager in the event of loss ofcommunication to the CallManager.
E. ISR can act as a voice gateway to the PSTN.

A.Wireless client WMM UP classification is translated to a wired DSCP priority.
B.Wireless client 802.11p classification is translated to a wired DSCP priority.
C.Wireless client WMM UP classification is translated to a wired 802.1p CoS priority.
D.Wireless client 802.11p classification is translated to a wired 802.1p CoS priority.

A.VTP mode
B.VTP password
C.VTP revision number
D.VTP pruning
E.VTP domain name
F.None of the other alternatives apply

A.The default route is missing from the Branch4 router
B.The IP address on the E0/0 interface for the Branch4 router has the wrong IP mask. It shouldbe 255.255.255.252
C.The network statement under router EIGRP on the Branch4 router is incorrect. It should benetwork 192.168.1.0 0.0.0.255.
D.When running EIGRP over GRE tunnels， you must manually configure the neighbor addressusing the eigrp neighbor ipaddress command.
E.The IP address on the tunnel interface on P4S-Branch4 is incorrect. It should be 192.168.1.12255.255.255.252

A.The compute node reboots and is then connected to the CMC
B.A compute node is assigned to a service profile
C.if the association is successful the cisco UCS manager boots the cisco UUOS to configure the compute  node
D.The compute node reboots to reload and then loads NX OS and establishes connections to both the CMC  and the IOMs